BA E16 en* 1.0 * E16_10_700.fm 7-35
Maintenance 7
Adding engine oil
1. Stop and park the vehicle. Stop the engine – see chapter “ Preparing
lubrication” on page 7-9.
2. Open the engine cover.
3. Wipe the area around the sealing push-in cap with a lint-free cloth.
4. Open filler cap B.
5. Raise oil dipstick A slightly to allow any trapped air to escape.
6. Add engine oil.
7. Wait at least five minutes until all the oil has run into the oil sump.
8. Check the oil level.
9. Add oil if necessary and check the oil level again.
10.Close filler cap B.
11.Slide in oil dipstick A completely.
12.Close and lock the engine cover.
Use a suitable container to collect fluids and lubricants as they flow out
and dispose of them in an environmentally friendly manner.
To Next Page
Loading...
Need help?
General
