wc_si000704gb_FM10.fm
13
LTV Safety Information
■ The lamps become extremely hot during use! Allow the lamp and fixture to cool
10–15 minutes before handling.
1.4 Metal Halide Lamp Safety
Description
The lamps provided with the machine are electric discharge lamps. They are
designed for use with metal halide ballasts only, and require time to reach full
brightness on initial startup and after a power interruption. These lamps comply
with FDA regulation performance standards 21 CFR 1040-30.
Operating
safety
Replace damaged lamps according to the instructions in section Removing and
Replacing Lamps.
WARNING
Personal injury hazard. Broken or punctured lamps can cause serious skin burns
and eye inflammation from shortwave ultraviolet radiation.
► Do not operate the machine if a lamp is damaged.
► Replace damaged lamps immediately.
To Next Page
Loading...
Need help?
General
