Wacker Neuson LTV8K User Manual

wc_tx004430gb_FM10.fm
50
Machine Setup LTV
4.11 Lowering the Tower—Power Winch System
Requirements ■ Lights are turned off
■ Engine is stopped
■ Outriggers are extended and locked in place
Procedure Perform the procedure below to lower the tower.
1. Hold the rotary switch (b) in the down position (“cable out” direction) until the
tower is completely lowered.
This procedure continues on the next page.
WARNING
Tipping/falling hazards. Certain actions may cause the tower to fall or the machine
to tip over.
WARNING
Personal injury hazard. Bystanders can be struck by the tower as it is being raised
or lowered.
► Do not allow anyone to stand near the front of the machine while raising or
lowering the tower.
wc_gr013773
a
b

Wacker Neuson LTV8K Specifications

General

Brand	Wacker Neuson
Model	LTV8K
Category	Work Light
Language	English