Safety Information RD 27
12 wc_si000247gb.fm
Safe
operating
practices
When operating this machine:
Always remain seated and wear the seat belt at all times while operating the
machine.
Remain aware of changing positions and the movement of other equipment and
personnel on the job site.
Be sure that all other persons are at a safe distance from the machine. Stop the
machine if people step into the working area of the machine.
Remain aware of changing surface conditions, for example, uneven ground,
hills, trench edges, soft or coarse material. Be sure that the surface is stable
enough to support the weight of the machine and that there is no chance of the
machine sliding, falling, or tipping.
Remain aware of the machine’s moving parts. Keep hands, feet, and loose
clothing away from the machine’s moving parts.
Wear protective clothing appropriate to the job site when operating the machine.
Wear safety glasses when operating this machine.
Store the machine properly when it is not being used. The machine should be
stored in a clean, dry location out of the reach of children.
When operating this machine:
Do not drive off curbs or other uneven surfaces that will result in jarring impacts
to the machine and operator.
Do not touch the engine or muffler while the engine is on or immediately after it
has been turned off. These areas get hot and may cause burns.
Do not allow anyone to ride on any part of the machine. Passengers can be
seriously injured or killed from falls, tip-overs, or roll-over incidents.
Do not leave the machine running unattended.
Do not operate a machine in need of repair.
Do not attempt to start the machine while standing alongside it. Only start the
engine when seated in the driver’s seat and with the forward/reverse control in
the neutral position.
Do not operate a machine when its fuel cap is loose or missing.
Do not use a cellphone or send text messages while operating this machine.
Do not operate the machine with unapproved accessories or attachments.
Do not transport the machine while it is running.