Using the cooler
41
7.5 Setting the temperature
➤ Press the “SET” button (fig. 3 4, page 3) once.
✓ The cooling temperature is shown.
I
Note
If no temperature is displayed, but only “LO”, press the “SET” but-
ton until the cooling temperature appears.
➤ Use the “UP +” (fig. 3 6, page 3) and “DOWN –” (fig. 3 7,
page 3) buttons to select the cooling temperature.
✓ The set cooling temperature then appears in the display for a
few seconds. The display flashes several times before it returns
to the current temperature.
7.6 Switching off the cooler
➤ Empty the cooler.
➤ Switch the cooler off by pressing the “ON/OFF” pushbutton
(fig. 3 1, page 3) for approximately 2 seconds until the
temperature display switches off.
➤ Set the battery switch (fig. 4 2, page 4) to “BATTERY OFF”.
➤ Detach the connection cable.
7.7 Storing the cooler
If you will not use the cooler for a longer period of time:
➤ Fully charge the internal battery.
➤ Set the battery switch (fig. 4 2, page 4) to “BATTERY OFF”.
In doing so, you prevent the internal battery from fully discharging
despite the cooler being switched off. Completely discharging the
internal battery will destroy it.
a
Caution – danger of damaging the device
Fully charge the internal battery at least every six months.
CF-32UP.book Seite 41 Donnerstag, 16. Juli 2009 5:21 17
To Next Page
Loading...
