Waeco CF80 - Setting the Temperature

EN
CoolFreeze Operation
35
I
A
➤ Press the “ON/OFF” button (fig. 2 1, page 3) for between one
and two seconds.
✓ The “POWER” LED lights up.
✓ The display (fig. 2 5, page 3) switches on and shows the
current cooling temperature.
I
✓ The cooler starts cooling the interior.
I
6.6 Setting the temperature
➤ Press the “SET” button (fig. 2 4, page 3) once.
➤ Use the “UP +” (fig. 2 6, page 3) and “DOWN -” (fig. 2 7,
page 3) buttons to select the cooling temperature.
✓ The cooling temperature appears in the display for a few
seconds. The display flashes several times and then the current
tempera-ture is displayed again.
NOTE
If you wish to operate the cooler from the AC mains, set the bat-
tery monitor to the “LOW” position.
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
NOTE
The temperature displayed is that of the middle of the interior.
The temperatures elsewhere can deviate from this temperature.
NOTE
When operating with the battery, the display switches off auto-
matically if the battery voltage is low. The LED “POWER” flashes
orange.