Safety information charging current distributor
16
2 Safety information
2.1 General safety
z Always disconnect the power supply when working on the charging current
distributor!
z If the cable is damaged, it must be replaced to prevent possible electrical hazards.
z Do not operate the device if it is visibly damaged.
z This device may only be repaired by specialist personnel. Inadequate repairs can
lead to considerable hazards.
Should your device need to be repaired, please contact WAECO customer services.
z Ensure that the charging current distributor is kept out of the reach of children!
2.2 Operating the device safely
z Do not operate the device near flames or other heat sources (heating, direct sunlight,
gas ovens etc.).
z Do not immerse the device in water.
z Protect the device and the cable against heat and moisture.
Caution!
WAECO International will not be held liable for claims for damage resulting
from the following:
– Installation errors
– Damage to the system resulting from mechanical influences and overvolt-
age
– Alterations to the device made without the explicit permission from WAECO
International
– Usage for other purposes than those described in the installation manual.
Warning!
To prevent short circuits, always disconnect the negative terminal of the vehi-
cle's electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should also be dis-
connected.
Warning!
Insufficient supply line connections could result in short circuits which
– Cause cable fires
– Trigger the airbags
– Damage electronic control devices
– Cause electric functions to fail (indicators, brake light, horn, ignition, light).
3 Scope of delivery
Quantity Description
1 Control unit
1 High-current load relay
_ECL-75_100.book Seite 16 Freitag, 22. Juli 2005 5:01 17
To Next Page
Loading...
