3
WAFERLOCK CORPORATION
• Master Pin Code can be programmed from 4 to 6 digits.
• Master Pin Code can be used to open door if no user code/card/tag is programmed, once a new
user is programmed, Master Pin Code will not be able to use to open the door.
• Master Pin Code can be used to open door if all user cards/tags are deleted.
Step 1
Step 2
Step 3
Step 4
Press any button to activate the keypad, then press 0 # to set up the Master Pin Code.
Enter Default Master Pin Code 123456, then press #.
Enter NEW Master Pin Code, then press #.
Re-enter the new 4~6 digits again, then press #.
Change Master Pin Code (Default is 123456)
Default Master Pin Code is 123456.
Correct Master Pin Code: 1 beep followed by green
light ashing 1 time.
Incorrect Master Pin Code: 2 beeps followed by red
light ashing 2 times, then standby.
If enter less than 4 digits or over 6 digits, 2 beeps
followed by red light ashing 2 times.
If code already exists, 2 beeps followed by red light
ashing 2 times, then standby.
If new Master Pin Code is programmed, 1 beep
followed by green light ashing 1 time.
If the code does not match rst code you entered,
2 beeps followed by red light ashing 2 times, then
standby.
If the code matches, 1 beep followed by green light
ashing 1 time.
Note
To Next Page
Loading...
