Wagan 2412 - Jumpstarter; Warnings; Procedure

©2015 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
www.wagan.com
7
3. Plug the large end of the DC power cord into an accessory (cigarette lighter) socket.
4. The red Charging Indicator will light up during the charging process. The indicator will stay
illuminated as long as the adapter is connected. Do NOT charge for more than 12 hours
at one time.
5. When charge is complete, disconnect the power cord from the accessory socket first, then
from the unit’s charging jack.
6. Press the Battery Status Button and observe the Battery Status Indicators for the state of
charge on the unit’s internal battery.
JUMPSTARTER
Warnings
• Lead-acid batteries can release explosive gasses. Failure to follow instructions
may cause property damage, explosion hazard, and/or personal injury.
• Do not smoke while jumpstarting.
• Jumpstart a vehicle or boat in a well ventilated area.
• Do not attempt to jumpstart a frozen battery.
• This product is not intended for use in the rain or temperatures above 130°F.
• Do not let the jumper cables or other attached appliances get wet.
• Do not wear vinyl clothing when jumpstarting—friction can cause static
electricity sparks.
• Remove all metal jewelry to avoid short circuits.
• Always use safety glasses when jumpstarting battery. Keep battery terminals clean and be
careful to keep corrosion from coming in contact with eyes—acid can cause blindness and/
or severe burns.
• Never allow red and black clamps to touch or connect to the same piece of metal—this can
cause short-circuits, power arcing, and/or explosion.
• Make sure someone is available to give assistance if needed.
• Keep out of reach of children.
Procedure
CAUTION: If the engine fails to start after three attempts, discontinue jumpstart procedure.
Excessive engine cranking can damage the vehicle’s starter motor. Look for other problems that
may need to be corrected or call for professional service.
1. Review the Jumpstarter warnings.
2. Put the vehicle’s gear is in “park” position and make sure the brake is set.
3. Turn off the vehicle ignition and accessories (e.g. radios, lights, air conditioners), and
disconnect all devices such as GPS and mobile phones or tablets.
4. Turn off all Battery Jumper switches and disconnect all accessories.