WAGNER Contractor Series

1012 • © Wagner Spray Tech. All Rights Reserved. Form No. 0529832A
NOTE: This manual contains important
warnings and instructions. Please read
and retain for reference.




Owner’s Manual • Manuel de l’utilisateur • Manual del usario

Call Wagner Technical Service at:
Appelez le service technique Wagner :
Llame Wagner Technical Service al:

Register your product online at:
Enregistrement du produit en ligne sur le site :
Regístrelo del producto en línea en:


WAGNER Contractor Series Specifications

General

Brand	WAGNER
Model	Contractor Series
Category	Paint Sprayer
Language	English

Summary

Important Safety Information

Explosion and Fire Hazards

Risks of flammable vapors igniting from solvents and paints.

Incompatible Materials Hazard

Warning about using materials incompatible with aluminum.

Hazardous Vapors

Dangers of inhaling or contacting harmful paint and solvent vapors.

Introduction to HVLP Spray Gun

Using the HVLP Spray Gun

Preparing the Spray Gun for Use

Steps for setting up the spray gun and cup before painting.

Selecting and Adjusting Spray Patterns

How to change the air cap for desired spray patterns.

Adjusting Spray Pattern Size

Spraying Techniques and Best Practices

Adjusting Material Flow Rate

Suction Tube Positioning for Angles

Cleaning the HVLP Spray Gun

Routine Maintenance Procedures

Adjusting the Packing Nut

How to tighten or loosen the packing nut to prevent leaks.

Replacing Needle Packing and Air Valve Seals

Instructions for replacing worn needle packing and air valve seals.

Replacing Air Valve Seals

Removing and Replacing Packing

Replacing Check Valve, Valve Seal, and Air Tubes

Replacing the Cup Gasket

Converting to Single Pin Trigger

Choosing the Correct Projector Set

Changing a Projector Set

Optional Accessories List

Repair Kits Overview

Troubleshooting Common Issues

No or Little Paint Flow

Diagnosing and fixing problems with insufficient material output.

Paint Leaking

Identifying causes and solutions for leaks from the spray gun.

Poor Spray Pattern

Troubleshooting issues causing uneven or defective spray patterns.

Regulator Cup Gun Parts Identification

Detailed Parts List and Specifications

Limited Warranty Information

Warranty Coverage Details

What defects are covered under the product warranty.

Warranty Exclusions

What is not covered by the limited warranty.

Consumer Rights and Limitations

Explains warranty transfer, remedies, and state law rights.