Intended use
The steam wallpaper remover is solely suited to remove wallpaper and for cleaning with
genuine Wagner special accessories.
To ensure long life of the steam wallpaper remover, clean your unit immediately and
thoroughly after each use.
Scope of delivery
1 Basic unit
2 Steam hose
3 Steam plate
4 Operating instructions
Safety instructions
Attention
When working with hot steam (approx.100°), there is a risk of serious
scalding.
If you change position during use, be very careful because the steam unit,
hose and plate can be very hot.
Always wear suitable protective clothing / gloves.
Operate the unit only with pure water without agents or additives. Do not
switch the unit on when it is not lled with water.
Never point the steam plate / bar at people, animals or at objects sensitive to
temperature.
Always ensure that the unit is standing securely in a horizontal position (on the
oor).
Do not stand on or place objects onto the unit or steam hose. Never over-twist or make
kinks in the steam hose, and never block the valve. Only carry the unit by its handle – and
in particular, never pull on the steam hose or mains cable.
Never submerge the unit in liquid. Every time the accessory is changed for, when lling /
relling and emptying or when the steam unit is not in use (including work pauses), pull
the mains plug out of the socket. Never overll the unit. Unplug the mains plug in the
event of overlling or a fault.
Do not use the device near combustible liquids and vapors.
Use only WAGNER original spare parts and accessories!
Caution! Danger of short-circuits! Cover sockets and switches and do not subject them
to steam.
Before connecting to the mains supply, be sure that the supply voltage is identical with the
value given on the rating plate.
When using an extension cable: max.10m long – the cable cross section must be at least 3 x 1 mm
2
.
2
3
4
To Next Page
Loading...
Need help?
General
