10
EN
PROPER SPRAYING TECHNIQUE
STOP
The room you are spraying must be properly
masked in order to prevent overspray from
covering woodwork, oors or furnishings.
Make sure you have properly masked the
room per the instructions on the enclosed
“Taping Guide”.
If spraying with an spray system is new or
unfamiliar to you, it is advisable to practice
on a piece of scrap wood or cardboard before
beginning on your intended workpiece and/
or test with water.
Watch videos on proper use and get tips
and tricks at www.wagnerspraytech.com/
sprayer-tips-and-tricks-videos/
SPRAY POSTER
A spray poster is included with your unit. The spray poster can
be adhered to a spraying surface and can be used for practice.
Follow the guidelines on the poster.
SURFACE PREPARATION
All objects to be sprayed should be thoroughly cleaned before
spraying material on them. Areas not to be sprayed may, in
certain cases, need to be masked or covered.
SPRAY AREA PREPARATION
The spray area must be clean and free of dust in order to avoid
blowing dust onto your freshly sprayed surface.
HOW TO SPRAY PROPERLY
STOP
It is important to keep your arm moving whenever the gun is
being triggered. If you pause or linger in one spot too long,
too much material will be sprayed to the surface.
• Position the spray gun perpendicular to and six (6) to eight (8) inches from the
spray surface, depending upon the spray pattern size desired. With reduced
material ow and air power, you can get closer to the spraying surface.
• Spray parallel to the surface with smooth passes at a consistent speed as
illustrated below. Doing this will help avoid irregularities in the nish (i. e.
runs and sags).
• Always apply a thin coat of material rst then allow to dry before applying a
second, slightly heavier coat.
• When spraying larger surfaces, overlap each spray pass by at least 50% This
will ensure full coverage.
• When spraying, always trigger the spray gun after spray pass has begun
and release trigger before stopping the pass. Always keep the gun pointed
squarely at the spray surface and overlap passes slightly to obtain the most
consistent and professional nish possible.
STOP
During a project, periodically wipe the nozzle tip with a cloth to remove any dried paint.
When you quit spraying for any length of time, turn the turbine OFF and place the spray gun into the spray
gun holder on the turbine.
6 - 8 inches
Correct
Keep stroke smooth and at an even speed
Incorrect
Do not ex wrist while spraying.
Light coat Heavy coat Light coat
To Next Page
Loading...
Need help?
General
