What to do if my WAGNER GA 250AL Paint Sprayer drips and won't shut off correctly?
If your WAGNER Paint Sprayer is dripping and not shutting off correctly, it could be due to a worn valve seat or valve ball. Check the valve rod and flat jet nozzle, and replace them if necessary. Also, the sealing screw might be too tight, so check the torque.
What to do if my WAGNER Paint Sprayer has a poor spray pattern?
If your WAGNER Paint Sprayer has a poor spray pattern, here are a few things to check: * The nozzle might be damaged, in which case you should replace it. * The nozzle might be too large; try selecting a smaller nozzle. * The product pressure could be too low; increase the product pressure. * The spray product viscosity may be too high; thin the spray product according to the manufacturer's instructions. * There might be a partial nozzle blockage; try cleaning the nozzle.
Why is there insufficient product output from my WAGNER GA 250AL?
If you're experiencing insufficient product output from your WAGNER Paint Sprayer, the issue could stem from several causes: * The nozzle might be too small; select a larger nozzle. * The product pressure might be too low; increase the product pressure. * The nozzle could be clogged; clean the nozzle. * The high-pressure filter at the pump might be clogged; clean or replace the filter.
How to fix valve rod leaks in my WAGNER Paint Sprayer?
If the valve rod is leaking in your WAGNER Paint Sprayer: * The seals at the valve rod might be damaged; try re-tightening the sealing screw. * Replace the sealing collar on the valve rod. * The valve rod itself might be damaged; replace the valve rod.
General| Flow Rate | 0.5 GPM |
|---|---|
| Type | Airless |
| Maximum operating pressure | 207 bar |
| Weight | 10 kg |
| Horsepower | 1.5 HP |
To Next Page