20
Meter Calibration
The meter has been calibrated at the
factory and should not require re-
calibration. If you need to have the
calibration veried, please contact the
Wagner Meters Sales Department to
purchase a calibration verication block
if you don’t already have one. Should
the meter need to have a calibration
adjustment, it will need to be returned to
Wagner Technical Services Department.
Meter Storage
For a long service life, it is important
to store your meter properly. Avoid
excessively hot or cold locations and keep
the meter in the case provided. Do not
store the meter in an area with excessive
electromagnetic interference, such as near
an electric motor, or where it could be
crushed, such as in front of a forklift. Do
not leave the meter in an operating kiln
during the drying cycle.
To Next Page
Loading...
