29
a calibration verication block is avail-
able. Anytime that the meter is not reading
correctly on the calibration block, it should
be sent to the factory for calibration.
#13 Veneers
Q: Can I use my Wagner moisture meter
to measure veneers?
A: Measuring moisture in veneer requires
specic procedures. Wagner has estab-
lished guidelines for measuring these
materials. See the “Measuring Veneer”
section of this manual for guidelines on
this procedure.
#14 Rough vs. Smooth Lumber
Q: Can I use my Wagner meter to
measure rough-sawn lumber?
A: When measuring rough-sawn lumber
press down rmly on the center of the
meter with approximately 3 pounds of
pressure to ensure good sensor plate
contact with the wood surface. Do not
To Next Page
Loading...
