Youwill need:
• Scrap material / cardboard
if the spray pattern becomes distorted or
stops completely while the gun is triggered,
follow any or all the procedures listed on
pages 12-14.
if you plan to be away from your spray
project for more than one hour, follow the
Short Term Storage instructions on page 15.
if youhavedifficultyachieving a goodspray
pattern,yourspraytip and gun filter may
not beidealfor the type of materialyouare
spraying.Referto the chartbelowand on
page75.
411 Thin stains, Minimum
-- Red
511 sealers
413
513 Thick latex
-- Yellow paints, Maximum
415 stains
515
Tip:
Trigger gun after starting the
stroke. Release the trigger
before ending the stroke. The
spray gun should be moving
when the trigger is pulled and
released. Overlap each stroke
by about 30%. This will ensure
an even coating.
Practice on a piece of scrap material/cardboard
Holdthe Spray GunLevel
CORRECT
0 _ _
(25- 30 cm)
IHCORRECT
10
To Next Page
Loading...
