Youwill need:
• Scrap material / cardboard
• Drop cloths to protect floors and
furnishings from overspray
1. Rotate spray tip forward to SPRAY position (a). Unlock
the spray gun trigger by turning the trigger lock down (b).
2.
Point the spray gun at a piece of scrap material/
cardboard. Squeeze and hold trigger for steps 3=5.
ON
3. Turn the power ON.
4. Turn the PRIME/SPRAY knob to
SPRAY - MAXIMUM PRESSURE.
5. Continue to squeeze trigger until the material
is flowing freely through the spray gun.
NOTE: Motor will cycle ON and OFF while
spraying to regulate pressure. This is normal.
6. Release the trigger and lock the spray gun.
To Next Page
Loading...
