!
Youwill need:
• The material you plan to spray
• Extension cord
• Waste bucket
1. Push the red inlet release
button to ensure proper inlet
valve operation.
2. Unclip the suction hose and return tube.
Place suction hose into material container (a).
Place return tube into a waste bucket (b).
OFF
3. Plug in the sprayer. Turn the
PRIME/SPRAY knob to PRIME.
Turn the power ON.
4. Hold return tube over waste
bucket until material is flowing
(approximately five seconds).
5. Turn power OFF.
6. Place return tube into material container
and clip tube and suction hose together.
To Next Page
Loading...
