(a) (c)
Youwill need:
• Adjustable wrench
1.
Attach the suction set to the pump
as shown. Make sure the conector
notches (a) snap over the pins (b)
on the pump inlet.
NOTE: If suction set is difficult to
press onto the pump, lubricate the
O-rings (c) and (d) as shown with
petroleum jelly.
2. Remove the plug from inside the
hose fitting and remove the cap on
the outlet valve. Discard both.
IMPORTANT: Do not plug in the power
cord until assembly is complete.
IMPORTANT: Do not carry the sprayer by
the suction set. Use the sprayer handle
when moving the sprayer.
iMPORTANT: if you plan to use spray
material contained in anything except a
round, one gallon container, you will not be
able to hook it to the container holder.
3.
Thread one end of the spray hose
to the outlet valve on the sprayer.
4. Tighten the hose with an adjustable
wrench.
5. Hook material container onto
the end of the sprayer handle
as shown (round, one gallon
containers only)
iB
To Next Page
Loading...
