English
12
TitleCleanup - Oil-based Materials
Cleaning the Material container:
1. Unplug the sprayer. Pour the remaining material back
into the original container.
2. Fill the container half full of the cleaning solution
appropriate to the type of material you sprayed (warm,
soapy water for latex-based materials; mineral spirits for
oil-based materials). Plug in the sprayer.
3. Attach the container and plug in the sprayer. Squeeze
the trigger until the solution comes though the sprayer
for several seconds.
4. Unplug the sprayer. Remove the container and properly
dispose of the remaining solution.
5. Make certain the sprayer is unplugged. Remove the
suction tube.
6. Move on to Cleaning the Components, page 14.
Make sure you clean the sprayer in a well-ventilated area whenever cleaning with flammable solvents.
To Next Page
Loading...
Need help?
General
