WAGNER PROCOAT MAX

Questions and Answers:

B
Brandon RivasJul 30, 2025
How to troubleshoot WAGNER PROCOAT MAX that does not start?
- C
  Christine StoneJul 30, 2025
  If your WAGNER Paint Sprayer isn't starting, make sure it's properly plugged in and that the ON/OFF switch is in the ON position. Note that the motor will cycle ON and OFF while spraying to regulate pressure - this is normal. Also, test the power supply voltage and replace the extension cord if necessary. If problems persist, take the sprayer to a Wagner Authorized Service Center.
A
Alisha JacksonAug 3, 2025
Why is my WAGNER Paint Sprayer gun leaking?
- D
  David ShawAug 3, 2025
  If your WAGNER Paint Sprayer gun is leaking, try tightening the handle. If the leak persists, the sprayer may require professional service.
C
Christian AndersonAug 7, 2025
Why WAGNER PROCOAT MAX Paint Sprayer gun will not spray?
- A
  Amanda MitchellAug 7, 2025
  If the spray gun of your WAGNER Paint Sprayer will not spray, there are several possible solutions. Turn the PRIME/SPRAY knob to SPRAY. Rotate the spray tip to the SPRAY position.
L
Lauren HaasAug 11, 2025
What to do if WAGNER Paint Sprayer pressure drops during spraying?
- J
  Jennifer ClarkAug 11, 2025
  If the WAGNER Paint Sprayer draws up material, but the pressure drops when the gun is triggered, resulting in a bad spray pattern, first ensure the PRIME/SPRAY knob is set to SPRAY for maximum pressure. Try replacing the spray tip with a new one. Additionally, thin or strain the material to improve flow.
M
mercadoadamAug 16, 2025
How to fix poor spray pattern (tailing) with WAGNER PROCOAT MAX?
- K
  kaitlyn39Aug 16, 2025
  If the spray pattern of your WAGNER Paint Sprayer is poor (tailing), first, ensure the PRIME/SPRAY knob is set to SPRAY for maximum pressure. Try thinning the material using an appropriate thinning solution and replace the spray tip.
J
Jennifer HayesAug 20, 2025
What to do if WAGNER PROCOAT MAX Paint Sprayer doesn't draw material in PRIME mode?
- P
  Pamela ChambersAug 20, 2025
  If the WAGNER Paint Sprayer starts but doesn't draw material when the PRIME/SPRAY knob is set to PRIME, the inlet may be stuck from old material. Push the red inlet release button to release it.
L
Lisa GonzalezAug 25, 2025
Why is the spray tip assembly leaking on my WAGNER Paint Sprayer?
- A
  Amanda HamptonAug 26, 2025
  If the spray tip assembly of your WAGNER Paint Sprayer is leaking, check the tip assembly and assemble it properly. If the problem persists, consider replacing the seal.