English
9
3. Getting
Material to
Flow
Start
You will need:
• Scrap material / cardboard
• Drop cloths to protect oors and
furnishings from overspray
Note: Motor will cycle ON and OFF while
spraying to regulate pressure. This is normal.
1. Rotate spray tip forward to
SPRAY position (a).
Unlock the spray gun trigger.
4. Turn the PRIME/SPRAY
knob to SPRAY - MAXIMUM
PRESSURE.
2. Point the spray gun at a piece
of scrap material/cardboard.
Squeeze and hold trigger
for steps 3-5.
5. Continue to squeeze trigger
until the material is owing
freely through the spray gun.
Note: Motor will cycle ON and
OFF while spraying to regulate
pressure. This is normal.
3. Turn the power ON.
6. Release the trigger and lock
the spray gun.
To Next Page
Loading...
Need help?
General
