English
19
Cleaning the
Spray Gun
Components
Start
You will need:
• Soft bristled brush
• Multi-Purpose Oil
• Warm, soapy water if using latex material
• Mineral spirits for oil based material
• Wrench
1. Peform the Pressure
Relief Procedure, page 7.
5. Install gun lter tapered-
end rst. Reassemble
spray gun.
4. Pour a few drops of Multi-
Purpose Oil inside gun housing.
2. Pull trigger guard to separate
from lter housing and unscrew
housing using a wrench.
Note: Tighten the wrench over the
wrench ats (a).
6. Install spray tip with arrow
pointing towards front of
spray guard tip.
3. Remove lter from spray gun.
Clean spray tip and lter with soft
bristled brush and appropriate
cleaning solution.
7. Install spray tip and guard
assembly.
Move on to Long Term
Storage, page 20.
To Next Page
Loading...
