T 25 K
GB
Page
Safety regulations ................................................................... 2
Functional description ............................................................. 2
What materials can be used? .................................................. 3
Technical data ............................................................................... 3
Equipment overview .................................................................. 3
Putting device in operating position ................................... 4
Transport by crane ..................................................................... 4
Placing into operation ........................................................... 5
Breaks in work ............................................................................ 5
Winter operation ......................................................................... 5
Placing out of operation and cleaning device ........5/6
Placing the device in its transport position ...................7/8
Contents
Page
Malfunction checklist .............................................................8
Servicing ................................................................................... 8/9
Sieve in pressure reducer ..................................................... 8/9
Tightening the special V-belt ..................................................9
Accessories ............................................................................. 9-11
Spare parts list - continuous mixer T 25 K ........................ 12
Spare parts illustration - continuous mixer T 25 K ......... 13
Spare parts list and illustration electric components .. 14
Spare parts list and illustration water ttings ................. 14
Important notes on product liability ........................... 15
Guarantee declaration .........................................................16
Declaration of conformity ................................................. 18
Wagner manufacturing and sales companies ........... 20
Safety regulations
Read the operating manual carefully and follow the
1.
instructions given therein, in order to avoid possible
danger.
The general safety and accident regulations for the building
2.
trade should be observed when using the continuous mixer
T 25 K.
3. Never put your hands into the continuous
mixer T 25 K when it is running.
The continuous mixer T 25 K should only be used with the 4.
coating materials listed on page 3. It is not permitted to use
it for any other purpose. The manufacturer will not be liable
for damages resulting from such improper use. The risks are
the sole responsibility of the user.
Always keep the operating manual available where the
5.
continuous mixer T 25 K is used.
Check the continuous mixer T 25 K for visible damage 6.
each time before putting it into operation. In particular,
the electrical lines, plug and couplings.
The protective devices, the protective grid on the container
7.
and the cover for the V-belt drive should be fastened
properly.
To avoid occupational illnesses, observe the processing
8.
instructions from the manufacturer of the material used
when preparing and using the materials and cleaning
device. Protective clothing, gloves and, if necessary, skin
cream are necessary to protect the skin.
Turn o the continuous mixer T 25 K before carrying out
9.
cleaning and maintenance work. Remove mains plug from
the socket.
10.
Cleaning the device
Never spray with sharp jet, in particular with high-pressure
or pressure steam cleaners. Danger of short circuit from
water getting in.
11.
Always remove the mains plug from the socket when
carrying out any work on electrical components.
Have all work or repairs to the electrical equipment carried 12.
out by a specialist electrician, even if there are references to
such in the operating manual. No liability will be accepted
for improper installation.
Functional description
The technical construction will be briey explained here in or-
der to enable a better understanding of the operation of the
device.
The protective grid with sack opener on the contain-
er protects the transport shaft from lumps in the coat-
ing material used. The electric motor drives the transport
and mixing shaft by means of a V-belt.
The transport shaft moves the coating material to be mixed
from the container to the dosing section and from there to
mixing section.
The water for the coating material ows from the water con-
nection over a xed adjustment pressure reducer to a solenoid
valve. This opens when the device is switched on.
The water ow is adjustable by means of the ne control valve.
A water ow display is available as accessory.
The water is added in the front region of the mixing pipe ac-
cording to the proportions stipulated by the coating material
manufacturer. A beating device on the mixing shaft means
that the coating material is mixed into water. The coating ma-
terial comes out at the end of the mixing pipe into a container
or conveying device.
To Next Page
Loading...