WAGNER T 25 K - Tightening the Special V-Belt

9
T 25 K
GB
1
3
4
2

Tightening the special V-belt (g. 17)
Remove mains plug from the socket.1.
Unscrew the 3 hexagon nuts (1, g. 17) with open-end 2.
wrench 13.
Remove cover (2).3.
Loosen the 4 hexagon bolts (3) with open-end wrench 13.4.
Set depth of impression on the idle belt section to 1-2 5.
mm with tension screw (4).
Turn V-belt pulley several times and check depth of
impression.
Re-tighten the hexagon bolts (3).6.
Fit the cover.7.
Achtung
Attention
For replacement of the V-belt, use only the spe-
cial Wagner V-belt.
1 2
3
1-2 mm
4

Accessories
Water ow display
Enables:
The water volume to be controlled for a certain coating mate-
rial according to the manufacturer's specications.
The readjustment of the water volume for a particular coating
material.
Part No. 0343 700

Cover
Serves as protection against humidity, dirt and as protection
against the wind.
Part No. 0343 701
1 0 2
Autom. Aus Hand
