17
W 180 P
GB
Problem Cause Remedy
Spray gun sucks in
but does not spray
•
Nozzle clogged
•
Ducts and holes in atomiser
clogged
➞ Clean
➞ Clean
Spray gun works but
sprays unevenly
•
Spray material in container
running out
•
Spray gun held inclined
leading to sucking in of air
•
Viscosity of spray material too
high (too thick)
•
Fine adjustment button not
set correctly
•
Nozzle worn out
•
Valve worn out
•
Wrong valve inserted
➞ Rell
➞ Use exible nozzle
extension (see accessories)
➞ Dilute accordingly
➞ Reset according to spray
material
➞ Replace
➞ Replace
➞ Use correct valve
Environmental protection
The device and all accessories and packaging have to be recycled in an
environmentally friendly manner. Do not dispose of the appliance with
household waste. Support environmental protection by taking the appliance
to a local collection point or obtain information from a specialist retailer.
Leftover paint and solvents may not be emptied into drains, the sewage system
or disposed of as household rubbish. It has to be disposed of separately as special
waste. Please pay special attention to the instructions on the product packaging.
Important Note regarding Product Liability!
According to an EU directive, the manufacturer is only liable without limitation for faults
in the product if all parts come from the manufacturer or have been approved by the
manufacturer and have been mounted to the device and are operated properly. If third-
party accessories or spare parts are used, the manufacturer is exonerated wholly or partly
from his/her liability if use of the third-party accessories or spare parts have caused a
defect in the product.
To Next Page
Loading...
Need help?
General
