Ensure that no solvent vapors are sucked in by the unit. Do not spray onto the unit!
•
The spray gun is not a toy; children must therefore not be allowed to handle it or play
•
with it.
Before working on the spray gun remove the power plug from the socket.
•
Cover areas that are
•
not to be sprayed. When working keep in mind that wind, for example,
may transport paint mist over great distances and cause damage.
The units may only be used with a functional valve.
•
If paints rises in the ventilating
hose (Fig. 12 A, item 14) do not operate the unit further! Dismantle and clean the
ventilating hose, valve and diaphragm and replace the diaphragm if necessary.
Do not lay the spray gun.
•
The device is equipped with a thermal release which disconnects the device in case of
•
overheating. In this case, turn o the device, remove the plug and let the device cool
down for at least 1/2 hour. Eliminate the cause of heating, e.g. bent hose, soiled air lter,
slots for air intake covered.
With original WAGNER accessories and spare parts, you have the guarantee that all
safety regulations are fullled.
Technical Data
Max. viscosity 170 DIN-s
Max. ow rate 240 g/min
Power source 230 - 240 V
~
Power consumption 570 W
Atomizing output: 130 W
Double insulation
Sound pressure level 80 dB (A)
Oscillation level < 2,5 m/s
Air hose length 3,5 m
Weight 5,7 kg
TechnDat_GB
Description (Figs. 1+2)
Air cap 1) Tip2)
Union nut 3) Standard spray attachment4)
Trigger guard 5) Material volume regulation6)
Gun handle 7) Air volume control8)
ON/OFF switch 9) Air hose10)
Carry handle 11) Cover12)
Bottom section 13) Main switch14)
Closure 15) Container16)
Gun holder 17) Valve18)
Ventilating hose 19) Air hose connection20)
Fastener for radiator/detail spray 21)
attachment (accessory)
Deposition tray for hardware22)
Cover of air lter compartment 23) Air lter24)
Cable grommet 25) Power cable26)
Air hose retainer 27) Deposition tray for spray attachments28)
Beschreibung_GB
To Next Page
Loading...
