EasyManuals Logo

WAGNER W 95 Manual

WAGNER W 95
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
14
W 95
GB
Handling Table for Viscosity
Thinner-soluble varnishes/
primers 20-35 20-45
Water-soluble varnishes /
primers 20-50 20-60
Automobile spray paint 18-22 18-22
Wood preservatives,
disinfectants, plant protectants,
polishes, strippers, oils undiluted
Hammer eect enamel 25-35 30-45
Aluminium paints 20-30 20-30
Measuring the Viscosity
Dip the viscosity test cup (Illus. 1) completely into the spray material. Hold the test cup up
and measure the time (in seconds) until the liquid empties out. Compare the measured
"runout time" with the Viscosity Table.
Start-up
Before connecting to the mains supply, please be sure that the supply voltage is identical
with the value given on the rating plate (on the side of the spray gun).
1) Dilute the spray material according to the above table.
2) Place the container on a sheet of paper and ll it with the prepared spray material.
Attention! Do not operate the spray gun without spray material in the
container; this can lead to increased wear of the pump!
3) Position the spray gun on the container and turn the container to the right until the
container ts tightly (Illus. 2, arrow).
4)
Activate the switch to start up the spray gun.
First the spray gun sucks in spray material, then after a few seconds the material emerges
from the nozzle. To accelerate the intake, turn the ne adjustment button to maximum.
5) By turning the ne adjustment button you can vary the spray amount (Illus.3,arrow).
i
Regulating with the ne adjustment button inuences the spray pattern
depending on the spray material and the degree of dilution.
Spray Technique
The spray result depends heavily on the smoothness and cleanliness of the surface to
be sprayed. Therefore the surface should be carefully prepared and kept free of dust.
Cover areas that are not to be sprayed. When working keep in mind that wind, for example,
may transport paint mist over great distances and cause damage.
Do not spray the vessel empty. The suction tube should always be immersed in liquid.
If air is sucked in, larger drops may result.

Other manuals for WAGNER W 95

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WAGNER W 95 and is the answer not in the manual?

WAGNER W 95 Specifications

General IconGeneral
BrandWAGNER
ModelW 95
CategoryPaint Sprayer
LanguageEnglish

Related product manuals