WAGNER W 950 FLEXIO - Multifunction Switch Settings (Fig. 4, A); Setting the Flow Rate When Working with the Spray Lance (Fig. 4, B); Setting the Width of the Spray Jet on the Spray Lance (Fig. 5)

D
42
W 950 Flexio
Wall paint
GB
42
W 950 Flexio
12. Multifunction switch settings (g. 4, A)
FILL/
CLEAN

Settings for cleaning and
pre-lling the system
OFF

System is o
ON

Operating setting
i
When using the spray
attachment for varnish paints
and glazes, the FILL/CLEAN
functions may not be used!
13. Setting the ow rate when working with the spray
lance (g. 4, B)
The material quantity is set depending on the characteristics of the material (viscosity)
and the working speed of the operator.
This setting can be made variably with the material ow limiter:
lower material

turn to the left
higher material

turn to the right
i
We recommend starting with a low material ow setting and then gradually
adjusting this to suit needs. .
14. Setting the width of the spray jet on the spray lance
(Fig. 5)
A = wide spray jet
(black)

For coating larger surfaces

Working with a large ow
rate (black area on quantity
scale)
B =
narrow spray
jet (white)

For coating smaller areas,
corners and edges

Working with a small ow
rate (white area on quantity
scale)
A
B

Volume
A
B
