Operating Instructions
10
TRANSPORT POSITION
The top cutting height (4”) is a locking position that
is called the Transport position. This position is
recommended for increased ease when driving the
tractor (transporting it) between mowing locations.
To Place Deck In Transport Position:
1. Disengage the PTO.
2. Push down on Deck Lift Pedal until it locks in
the Transport position.
Tab Locked Full
Forward For
Transport
Position
Transport Position
To Release From Transport Position:
Push down on the Deck Lift Pedal while lifting the
Height Adjustment Arm to release the deck back to
the Set Cutting Height.
LOCKOUT ARM
The A54 is equipped with a Lockout Arm that keeps
the Deck Height Adjuster from locking in the Trans-
port position. The Lockout Arm can be used when it
is necessary to make temporary height increases
while mowing. This feature can be helpful when
mowing leaves that might build up on the front of
the deck.
For Temporary Height Adjustments
1. With the Lockout Arm engaged, press down on
the Deck Lift Pedal while mowing.
2. Slowly release the Deck Lift Pedal to return the
deck to the Set Cutting Height.
WARNING
Never change the Set Cutting Height while
the mower is moving. Only a temporary
height increase can be made with the Lock-
out Arm engaged while mowing.
Lockout Arm
Engaged
Normal Operating
Mode
Lockout Arm Positions
To Next Page
Loading...