67
B27i Maintenance Instructions
Adjustments
Tilt-Up Deck Adjustable Stop
When the carrier frame hinge joint is properly
ad justed, the deck lock levers should move in and
out of the engaged and disengaged positions
freely. All four (4) hitch pins used for height adjust-
ment should sit ush on the washers above the
deck pin bushing. On a level surface, if any pin is
sticking up (likely the front pins), tighten the oppo-
site side or loosen the same side to lower the pin.
Adjustments are made by loosening the jam nut
and tightening or loosen ing the set screws on the
Deck Mount Pivot Brack ets. Retighten the jam nut
when the adjustment is complete.
Jam Nut
Set Screw
Tilt-Up Deck Adjustable Stop
To Next Page
Loading...
