8
Beginning S/N 168757
Use only genuine Walker
®
replacement parts.
ITEM PART DESCRIPTION NO.
NO. NO. REQ’D
ITEM PART DESCRIPTION NO.
NO. NO. REQ’D
MAIN COMPONENT POWER TRANSMISSION
Clutch Lever Assembly
1 8358-3 Clutch Lever (Includes Items # 2 & 3) 1
2 5830 Grease Fitting 7
3 4850 Handle Grip, Black 1
4 7303-10 Clutch Actuator Bolt (3/8) 1
5 7380-5 Knuckle Joint (3/8 ID) 1
6 7226-10 Compression Spring (3/4 x 2-1/2) 1
7 8130-5 Pushrod, Clutch Actuator (Threaded Tube) 1
(Includes Item # 2)
8 8130-10 Clutch Actuator Rod Assembly 1
(Includes Items # 2, 4-7,
F054, F336 & F353)
9 7201-3 Fiberglide Bearing 6
10 7201-5 Inner Race (2-1/4) 1
11 8368 PTO Belt Tightener 1
12 5841 Retainer Washer (3/8 x 1-1/4) 4
13 8243-1 Clutch Idler Pulley 1
8243 Clutch Idler Pulley Assembly *
(Includes Items # 13-15 & F070)
14 5265 Bearing (3/4) 1
15 8243-3 Hub, Idler Pulley 1
16 8375 PTO Belt Tightener Stop 1
17 7377 Plastic Washer (1 x .438 x .025) 2
18 7378 Pivot Bearing (7/16 x 9/16) 1
19 5281-5 Clevis Pin (1/4 x 0.80) 2
20 5280 Clevis (1/4) 2
21 8305 Brake Actuator Rod 1
22 8370 Bearing, Brake Actuator 1
23 8250 Brake Spring (1/2 x 2-1/2) 1
24 8369 Brake Actuator (Includes Items # 2 & 22) 1
PTO Drive Shaft Assembly
25 7050-1 Dipstick, Gearbox 1
26 8371-1 Mount Bracket, Brake Band 1
27 8377 Brake Band Guide 1
28 8050-11 PTO Gearbox / Flange Pulley 1
29 7248 Ground Drive Belt, Micro-V 1
30 7275-9 Quick Coupler Installation Tool **
31 7275-16 Universal Joint Tube Assembly (Spline) 1
32 8304 Brake Band (14-1/2) 1
33 7523-2 Clevis Pin W/Hole (1/4 x 5/8) 1
34 6250-1 Drive Belt (3VX370) 1
35 7236-1 PTO Drive Pulley (4-1/2/3V) 1
(Includes Items # F168 & F226)
36 8237-2 Engine Pulley, Bolt On (4/3.8/3V) 1
(Includes Items # F168 & F226)
37 8230 Engine PTO Belt 1
Jackshaft Assembly
38 7245-1 Idler Pulley (3/8 Groove) 1
39 6325-2 Spacer Bushing (5/16) 2
40 8349-4 Idler Arm 1
41 7201-4 Inner Race (1-1/2) 2
42 5221-1 Extension Spring (3/4 x 5) 2
43 7833 Cable Clamp (7/8 x 1/4) 2
44 8539 Starter Relay Mount 1
45 7241-2 Transmission Drive Pulley (3-1/4MV) 1
(Includes Items # F067 & F171)
46 5268 Bearing W/Collar (3/4) 2
47 8349 Transmission Belt Tightener Arm 1
48 5245 Idler Pulley (3") 1
49 8393-7 Hydro Jackshaft Mount 1
8394-1 Hydro Jackshaft Mount Assembly *
(Includes Items # 2, 9, 41, 46, 49 & 50)
50 8273 Jackshaft (3/4 x 7-1/2) 1
51 7240-4 Jackshaft Drive Pulley (3.3/3V) 1
(Includes Items # F067 & F171)
Fasteners
F002 10-24 Keps Nut 1
F003 1/4-28 Hex Nut 2
F004 1/4-20 Keps Nut 3
F005 1/4-20 ESNA Nut 1
F009 5/16-18 Whiz Locknut 3
F012 3/8-16 Keps Nut 7
F025 10-24 x 3/8 PPHMS 1
F029 1/4-20 x 1/2 Hex Bolt 1
F034 5/16-18 x 3/4 Hex Bolt 2
F041 3/8-16 x 1-3/4 Hex Bolt 2
F042 3/8-16 x 2-1/4 Hex Bolt 3
F043 3/8-16 x 3 Hex Bolt 1
F047 3/8-16 x 4-1/2 Hex Bolt 1
F054 AN960616 Washer 3
F061 1/4 Internal Star Lock Washer 1
F067 3/16 x 3/16 x 1 Key 2
F069 3/32 x 1/2 Cotter Pin 3
F070 1-3/4 Internal Snap Ring 1
F090 1/4-20 x 2-1/2 Hex Bolt 1
F116 1/4-20 x 1-1/4 Hex Bolt 1
F121 5/16-18 x 3/8 x 1 SHL Bolt 1
F131 5/16-18 x 1/2 Hex Bolt 2
F132 1/4-20 x 2-3/4 Hex Bolt 1
F168 5/16 Split Lock Washer 14
F171 5/16-18 x 3/8 Set Screw 4
F178 1/4 x 1 Fender Washer 1
F182 1/4 x 5/8 x 1/8 Washer 2
F226 5/16-18 x 7/8 Hex Bolt 14
F241 .375 x .875 x .10 Washer 1
F261 AN960616L Washer 1
F336 3/8-16 Jam Nut 1
F353 3/8-16 ESNA LP Nut 1
* Service Part Only
** The Quick Coupler Installation Tool is used to assist the instal-
lation of the Quick Coupler Tube and PTO Shaft connection by
holding the disconnect ring in the retracted position when
joined to the tractor spline shaft on the PTO gearbox.
To Next Page
Loading...
Need help?
General
