Walker C19 - Maintenance and Schematics; Lubrication Points

ITEM LOCATION LUBRICATION NO.
NO. TYPE PLACES
ITEM LOCATION LUBRICATION NO.
NO. TYPE PLACES
30
Beginning S/N 168757
Use only genuine Walker
®
replacement parts.
LUBRICATION POINTS
Lubrication Points
1 Steering Lever Pivot Grease 4
2 Body Hinge Point Oil 2
3 Deck-to-PTO Coupling Grease 1
(Grease Spline Slide Area)
4 FSC Actuator Rod Pivot Pins Oil 2
5 (FSC) Friction Body Pivot Grease 1
6 FSC Lever Pivot Grease 1
7 Deck Support Arm Pivot Grease 2
8 Gear Axle Oil** 2
9 Universal Joint Tube Assembly Grease* 1
10 Parking Brake Lever Pivot Grease 1
11 Universal Joint Quick Connect Grease 1
Spline (Grease Slide Area)
12 Hydrostatic Drive / Oil Reservoir Oil** 3
13 Belt Tightener Pivot, Grease 1
Jackshaft Drive
14 PTO Clutch Lever Pivot Grease 1
15 Clutch Actuator Push Rod Grease 2
16 Belt Tightener Pivot, Grease 1
PTO Clutch
17 Brake Actuator Rod and Brake Oil 3
Band Pivot Pins (Clevis)
18 Brake Actuator Pivot Grease 1
19 Choke Control Cable Ends Oil 2
20 Catcher Hinge Point Oil 2
21 Throttle Control Cable Ends Oil 2
22 Engine Dipstick / Oil Fill Oil** 1
23 Belt Tightener Pivot, Grease 1
Blower Drive
24 Belt Tightener Pivot, Grease 1
Ground Drive
25 PTO Gearbox Dipstick Oil** 1
26 Choke Control Pivot Oil 1
27 Throttle Control Pivot Oil 1
* Grease every 25 hours.
** See Operator’s Manual for procedure for checking and
changing oil in Engine Crankcase, Hydrostatic Transmissions,
and Gear Axles.
NOTE: See Model C19 Operator’s Manual (P/N 6000-31)
for proper lubrication intervals.