FX66, FX85, FX110, FX140
PTO Skidding Winch
Safety
Safety
15
6. Warning!
Crushing hazard.
Do not stand in front of the winch when
using it. Stand to the side at a minimum
10 ft (3 m) away.
7. Warning!
Be aware of the risk of injury from flying
objects. Stay behind the protective screen
when possible. Rope could release from
a log unexpectedly and snap back fast
enough to cause injury.
8. Warning!
Always wear appropriate Personal
Protective Equipment when using this
machine. For example:
• A hard hat
• Heavy gloves
• Hearing protection
• Protective shoes with slip
resistant soles
• Protective glasses, goggles or
face shield
IMPORTANT! If parts are replaced that have safety signs on
them, new signs must be applied. Safety signs must always
be replaced if they become damaged, are removed, or
become illegible.
Safety signs are included in the product decal kit available from
your authorized dealer. Decals are not available separately.
2.10.1 Replacing Damaged Safety Signs
• Always keep safety signs clean and legible.
• Replace safety signs that are missing or have become
illegible.
• Parts that were replaced with a safety decal on them must
also have the safety sign replaced.
• Replacement safety signs are available from your
authorized Distributor, Dealer Parts Department, or
Wallenstein Equipment.
Procedure
1. Be sure that the installation area is clean and dry.
2. Be sure temperature is above 50 °F (10 °C).
3. Determine exact position before removing from the backing
paper.
4. Pull the decal off the backing sheet, align the sign over
the specified area, then carefully press the exposed sticky
backing in place.
5. Use a piece of the backing paper to smooth the decal out,
pressing from the center outwards.
6. Small air pockets can be pierced with a pin and smoothed
out using the piece of sign backing paper.
To Next Page
Loading...
