36
Coupler
Connected
Fig. 35 HYDRAULICS
Fig. 34 ALIGNING
6. Drive up to the backhoe while
aligning the mounting compo-
nents.
7. Connect the hydraulics:
a. Use a clean rag or paper
towel to clean the dirt from
the couplers on the hose
ends and the skid steer.
b. Connect the hoses to the
skid steer couplers. Be sure
the couplers are securely
seated.
c. Route and secure the hoses
along the frame with clips,
tape or plastic ties to pre-
vent binding and pinching.
Be sure to provide slack for
tilting.
To Next Page
Loading...