What to do if my Walrus Water Pump does not start?
If your Walrus Water Pump isn't starting, first, examine the power source, fuse, or circuit breaker to ensure they haven't failed. Second, inspect the pump for blockages caused by sand, rust, or foreign objects. Finally, test the motor for any defects that may be due to overload or other issues.
Why is my Walrus TPH running at reduced capacity or has no discharge water?
If your Walrus Water Pump is running at a reduced capacity or has no water discharge, there are several potential causes. If you have a three-phase motor, verify the rotation direction is correct. Also, ensure the inlet source is sufficient and the temperature is within the normal range. Lastly, inspect the suction pipes and valves for leaks, and check the mechanical seal for defects.
General| Maximum operating pressure | 10 bar |
|---|---|
| Pump casing material | Cast iron |
| Frequency | 50Hz or 60Hz |
| Material | Cast iron, Stainless steel |
| Model | TPH Series |
| Power | 0.37 - 2.2 kW |
| Voltage | 220-240V / 380-415V |
To Next Page
