12
Projector Hanger Installation Guide
Step 1: Remove the Protective Pads
Carefully remove the four protective pads from the bottom of the projector. These pads are typically
located at each corner and are used for stability during transport. Ensure all pads are removed before
proceeding to the next step.
Step 2: Align and Adjust the Hanger
Position the hanger above the projector and adjust its angle to ensure the mounting holes align with
those on the projector. Once aligned, secure the hanger by tightening the screws provided. This step
is crucial for maintaining stability, so make sure each screw is firmly tightened.
To Next Page
Loading...
