Page | 6
UNBOXING AND ASSEMBLY
Wheel Kit Installation
The unit comes with the rubber mounting feet installed. If you wish to install the wheel kit, please
perform the following procedure.
Parts Included:
1. Axle assembly (1)
2. Locking swivel wheel (2)
3. Bolt M8X16 (4)
4. Wheel (2)
5. Bolt M6X16 (8)
Wheel assembly:
First remove all four rubber mounting feet.
Put a washer on each side of the wheel then slide them on the axle securing with a lock pin.
1. Wheel (2)
2. Axle (1)
3. Lock pin (2)
4. Washer (4)
Locking swivel wheel.
Secure each locking swivel wheel with
4 M6X16 bolts.
1. Locking swivel wheel
2. Bolt M6X16
To Next Page
Loading...