Why does W&H LINA MB17 Medical Equipment go into sleep mode immediately after opening the door?
If your W&H Medical Equipment enters 'Sleep mode' immediately after opening the chamber door, it is likely because the door wasn't opened after the previous cycle, and the 'Sleep mode delay' has expired. Press any button on the control panel to exit 'Sleep mode'.
Why is sterilization phase of W&H LINA MB17 cycle longer than expected?
If the sterilization phase of a cycle in your W&H Medical Equipment was longer than expected, it could be because the chamber temperature dropped below the minimum threshold, and the software performed a successful recovery. Wait for cycle completion. If the problem occurs frequently.
General| Brand | W&H |
|---|---|
| Model | LINA MB17 |
| Category | Medical Equipment |
| Language | English |
Covers safety, intended use, and manual details.
Lists essential safety rules for operating the sterilizer.
Guides on sterilizer placement and electrical connection requirements.
Identifies controls and connections on the front, service, and rear panels.
Explains the sterilizer's display screen layout and icons.
Details the functions of navigation buttons and the ECO-B option.
Guides through initial parameter setup and menu system usage.
Steps for selecting and initiating sterilization cycles.
Descriptions of B UNIVERSAL and B PRION cycles and their uses.
Specific loading instructions for ECO-B cycles.
How to schedule cycles to start at a future time or after an interval.
Guides on modifying drying time and plateau phase parameters.
Details the real-time status displayed during a cycle.
Steps for a successful cycle completion and unlocking the chamber door.
Overview of the maintenance program and tracking consumable usage.
Procedures for cleaning door seals, chamber, trays, and rack.
Step-by-step guide for replacing essential filters.
Instructions for cleaning the internal water tanks and filters.
Detailed procedure for replacing the door seal.
How to view and address pending messages and warnings displayed.
Lists common operational problems, their causes, and recommended solutions.
Guidelines for responsible disposal of the sterilizer and consumables.
Procedures for cleaning, disinfecting, and lubricating dental handpieces.
Best practices for cleaning instruments and loading trays for effective sterilization.
Specific methods for loading tubes and bagged items into the chamber rack.
Instructions for conducting the test to validate textile load sterilization.
Procedure for testing hollow item sterilization effectiveness.
Steps for performing the vacuum test to assess pump and circuit integrity.
Information on S'Print and LisaSafe printers and their functionalities.
Details on bacteriological filters, door seals, dust filters, and consumable kits.
To Next Page
