W&T
Content
1 Quickstart 9
1.1 Flow chart – Network installation using WuTility 10
1.2 Overview of configuration menu 11
1.3 Factory Default settings 12
2 Assigning the IP address 13
2.1 Configuring network parameters with WuTility 14
2.2 Assigning the IP using the ARP command 18
2.3 Serial assigning of IP, subnet mask and gateway 20
2.4 Assigning the IP using DHCP protocol 24
2.5 Assigning the IP using BOOTP protocol 28
2.6 Assigning the IP using a RARP server 30
3 Form factors 31
3.1 Com-Server Highspeed Industry 32
3.2 Com.Server Highspeed Isolated 58633 33
3.3 Com-Server Highspeed Office 34
3.4 Com-Server Highspeed 19“ 35
3.5 Com-Server Highspeed OEM 58431 36
3.6 Com-Server Highspeed compact 58231 37
4 Supply voltage 39
4.1 Com-Server Highspeed Industry and Isolated 40
4.2 Com-Server Highspeed Industry 58631/UL 41
4.3 Com-Server Highspeed Industry PoE 42
4.4 Com-Server Highspeed Office 43
4.5 Com-Server OEM and compact 44
4.6 Com-Server Highpeed 19“ 45
5 Interfaces and displays 47
5.1 Ethernet connection 48
5.2 RS232/422/485 combi-module 50
5.2.1 Opening the Com-Server 50
5.2.2 Mode selection 51
5.2.3 RS232 mode (factory default) 51
5.2.4 RS422/485 mode 53
To Next Page