Instruction Handbook KL
Chapter 5
BA KL V11 en 10/2014 page 5-3
Do not work on rotating pump!
Switch the plant into a voltage-free condition and secure against any unauthorized and
accidental restart!
Use protective gloves and safety glasses at work with aggressive detergents!
1. Connect pump to CIP cleaning system.
2. Start pump.
3. Clean pump and tube system.
4. Shut off pump, remove CIP - medium restless.
The CIP – cycle have to correspond to all current regulations and directives
for food industry. Especially the stability of materials must be observed.
If you have developed your own CIP processes for your process media,
check with the pump supplier that the pump is suitable for the process in
question where there is any doubt. In this connection pay special attention to
the elastomeric material and pump design.
5.2 ATEX pumps
In areas where there is a risk of explosion, these pumps must be operated in accordance with the
requirements in Directive 2014/34/EU (ATEX – directive).
When starting up these pumps, follow the safety instructions for explosion
protection in Chapter 1.
Before starting, make sure especially;
that the information on the nameplate of the pump accords with the information for the
area of use and
The required monitoring devices have been installed according to the hazard concerned
and are operating properly.
Rotating parts or pressurised spout liquids can cause fatal injuries.
Possible dangerous situation: Severe or fatal injuries!
To Next Page
Loading...
Need help?
General
