866082_h•en•2016-01-01We reserve the right to carry out improvements
4
OTEN Only the receiver is capable of learning, not the
transmitter. Learning in auxiliary channels is the
first step to building groups. When you wish to
learn in an auxiliary channel, do not perform
the power-up procedure, as you will need to
start the learn mode using the master channel.
OTEN An auxiliary channel can be a 1-channel trans-
mitter, one channel of an 8-channel transmitter, a
channel of the EWFS Timer or a weather station.
OTEN IMPORTANT! A receiver can manage one
master channel and up to 15 additional auxiliary
channels, for a total of 16 different channels.
Any attempt to learn in a greater number of
channels will fail.
OTEN For learning transmitters into other products,
as well as additional information on the topic
of learning-in, please refer to the operating and
installation instructions for the receivers.
Maintenance and cleaning
Replacing the batteries
The batteries are low if the transmission LED flashes when
a move command is triggered, does not light up at all or if
there is no reaction to the triggered move commands.
n In order to replace the batteries (type AAA, IEC LR03,
"Micro"), open the battery compartment (Fig.3), remove
the low batteries and insert new ones. Ensure the cor-
rect polarity: The plus (+) and minus (-) poles of the
batteries must agree with the marks in the battery com-
partment.
n Only use new batteries of the same type and always
replace both batteries. Use high-quality batteries - in-
expensive batteries can leak and damage the device.
If the device is not used for a longer period, please
remove the batteries. Do not use storage batteries (re-
chargeable batteries)!
Cleaning:
Clean the enclosure with a soft, damp cloth. Do not use
any scouring agents, solvents or steam cleaners!
Liability
Failure to comply with the product information in these
instructions and use of the device in a manner that con-
travenes its intended use and purpose may result in the
manufacture refusing to honour warranty claims for prod-
uct damage. In this case, liability for consequential harm
to persons or damage to property will also be excluded.
Follow also the instructions in the operating manual of
your sun shading system. The automatic or manual opera-
tion of the sun shading system when iced over as well as
using the sun shading system during severe weather may
cause damages and must be prevented by the user by
taking suitable precautions.
NOTE
: The device meets the requirements on interfer-
ence resistance and interference emission for
use in residential and commercial areas..
User information
For use in the following countries:
A, B, D, DK, E, F, FIN, GB, GR, I, IRL, L, NL, P, S, CH, IS, N.
The declaration of conformity can be reviewed at:
http://www.warema.de
Disposal
After use, the device and the batteries must be disposed
off according to legal regulations or returned to your local
recycling centre!
To Next Page
Loading...