Waring CB15 SERIES - Variable Speed Operation (CB15 V;CB15 VP); Variable Speed Control; Momentary Operation and Safety

10
CB15V/CB15VP OPERATION
1. Before starting, make sure that the blender cord is
unplugged.
2. Position container assembly
on motor base so that it is
rmly seated and not tilting
to one side. Plug blender cord
into outlet.
3. Put ingredients into container. Always add liquid
ingredients rst, unless otherwise specied in recipe.
Do not ll above Max line. Place cover securely on
container and fasten the cover clamps.
4. Press the green STANDBY button to turn on the
blender. Green LED will illuminate and remain steady.
Select the desired speed with the variable speed
control knob. Press the red START/STOP button to
begin blending. You may change the speed with the
variable speed control knob anytime during blending.
When nished blending, press START/STOP button.
For momentary operation, press the gray PULSE
button; motor will run on HIGH speed until the button
is released. The green LED will blink during operation.
5. Always hold container with one hand when starting
and while blending. Never operate without container
lid properly clamped in place.
6. Allow motor to come to a complete stop before
removing container. Never place the container on the
motor base or remove it from the motor base while
the motor is running.
7. Press the STANDBY button again to turn off the
blender.
8. Remove the container from the motor base and
empty the contents.