Waring CB15 SERIES - Hot Blending Lid Instructions; Lid Assembly and Disassembly; Lid Component Integrity

12
FOR CB15S AND CB15TS MODELS ONLY:
Hot Blending Lid Instructions
Model number: CBL10
CAUTION
DO NOT BLEND HOT MATERIALS UNTIL BLENDER
AND HOT BLENDING LID ARE CORRECTLY
ASSEMBLED. WHEN BLENDING HOT MATERIALS
ALWAYS FOLLOW THESE INSTRUCTIONS AND
THE INSTRUCTIONS IN THE 4 LITER BLENDER
OPERATING MANUAL.
TO ASSEMBLE:
1. Place lid with gasket over bafe cup and rotate lid
counterclockwise until locking tabs snap into place with
locking tab locks.
2. Place lid, with bafe cup attached, on top of container
and lock with locking clips on container.
Caution – DO NOT COVER ANY HOLES OR OPENINGS
IN THIS LID WHEN HOT BLENDING.
Important – The gasket mounted on the underside of the
hot blending lid is a critical component. If it shows signs of
cuts, tears, cracking, drying out, wear or other deterioration,
it must be immediately replaced before further use. Do not
overll container; maximum capacity is 4 liters.
TO DISASSEMBLE:
1. Be sure blender is turned off and lid has cooled.
2. Remove container from base.
3. Release locking clips on container and lift lid off.
4. Holding bafe cup, rotate lid clockwise until locking tabs
snap open and lift lid off bafe cup.