TROUBLE SHOOTING
Safety Cut-Out device:
To ensure against the potential hazard
caused by blockage of the air outlet, this
unit is equipped with an automatic over-
temperature safety cut-out device. When the
device is activated the heater will not operate.
If this occurs, the unit can be reset using the
following procedure.
1. Turn the re o by depressing the On/O
switch on the unit.
2. Unplug the power cord form the electrical
mains supply socket and leave it
disconnected for at least 10 minutes.
3. Ensure that the air vents are free from
obstruction.
4. Plug the power cord back into the mains
socket.
5. Turn the re back on.
6. If the re fails to operate, check the fuse
in the plug.
7. If the fuse in the plug is ok and the re is
still not functioning, contact a qualied
service person for repair.
Symptom Potential cause Corrective action
The re won’t turn on. Mains plug is not plugged
in.
The On/O switch hasn’t
been switched on.
The fuse in the plug has
blown.
Check the mains socket to ensure the
plug has been inserted correctly.
Switch on using the operation switches.
Contact the manufacturer or a qualied
repair service agent for repair.
No heat. One or both of the heat
selector switches have not
been switched on.
Ensure that the heat selection switches
have been correctly switched on.
Heater operates and
then the heat cuts out.
The safety cut-out may
have switched the re o.
Follow the procedures as outlined in the
“safety cut -out device” section.
To Next Page
Loading...
