EasyManua.ls Logo

Warmlite WL45026 - Safety Cut-Out System

Warmlite WL45026
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
www.warmlite.co
room temperature. Do not use
this heater in small rooms when
they are occupied by persons
not capable of leaving the room
on their own, unless constant
supervision is provided.
Always ensure that the heater is
placed on a rm level surface.
Ensure that the heater is not
positioned close to curtains,
furniture or any combustible
materials as this could create a
re hazard.
Never sit or stand on the re.
Never use this surround with a
gas re
Never stand or sit on the
surround.
Never cut o the plug and hard
wire into a xed fused spur.
The heater must not be located
immediately below a mains
socket outlet.
Do NOT cover the heater as
this may lead to a re risk.
Do NOT obstruct any of the
openings of the heater.
Do NOT insert any object
through any openings on the
heater.
Check the heater from time to
time for accumulated dust.
Do NOT use the heater in areas
where ammable liquids are
stored or where ammable
fumes may be present.
Do NOT operate the heater on
a timer, or leave on overnight.
When not being used, please
unplug the heater from the
mains socket.
Keep the mains lead away from
the hot body of the heater and
ensure that it is not pulled tight
between the socket and the
heater.
Always unplug the heater and
allow it to cool before moving it
from one location to another.
WARNING! This product must
be installed correctly, failure
to do so may cause damage
to your product and/or your
surroundings.
Do not attempt to dismantle or
repair any part of the heater.
This should only be done by a
qualied service agent.
In the unlikely event the
appliance develops a fault,
stop using it immediately and
seek advice from the service
department.
HIGH VOLTAGE HOT SURFACE DO NOT COVER

Related product manuals