Warmlite WL45038 - Setting the Timer; Adjusting Flame Effect

11
www.warmlite.co
• Press the ‘Correct’ button on the unit’s
control panel to begin selecting and
adjusting the time and date. Press this
button once to select the hours, press it
again to select the minutes, and press it a
third time to select the day of the week..
• The corresponding indicators or digits on
the LCD control panel will ash to indicate
they have been selected and can now be
adjusted.
• When each setting has been selected,
press the + or - buttons on the unit’s
remote control to manually adjust it.
• The unit will automatically save the
selected settings to memory after a few
seconds. The corresponding indicators or
digits on the LCD control panel will stop
ashing to indicate each setting has been
saved to memory.
Setting The Timer:
Note: Ensure the correct time and date have
been set before attempting to program a timer.
• Press the ‘Set’ button on the unit’s remote
control to begin setting a timer. The
‘Timer’ indicator on the unit’s control panel
will light up and begin to ash to indicate
timer selection mode has been activated.
• Once this mode is activated, press the
‘Set’ once to select the starting day for
the timer. The ‘ON’ indicator will light up
on the unit’s control panel to indicate the
start timer is now being selected. Once
this indicator is lit, press the ‘SET’ button
again to select the starting hour, press it
a third time to select the starting minutes,
and press it a fourth time to select the
desired operating temperature. The
corresponding indicators or digits on the
LCD control panel will ash to indicate
they have been selected and can now be
adjusted.
• When each setting has been selected,
press the Up and Down arrows on the
unit’s remote control to manually adjust
it. Press the ‘Set’ button again once each
setting has been adjusted to move on to
the next one.
Note: When selecting the starting or ending day
for each timer, ensure the Down arrow indicator
on the unit’s control panel lights up; otherwise,
the timer may not have been properly saved to
memory or activated.
• Press the ‘Set’ button again once all the
settings have been adjusted to move on
to the ending date and time selection. The
‘OFF’ indicator will light up on the unit’s
control panel to indicate the end timer is
now being selected. Once this indicator is
lit, repeat the process as detailed above to
set the ending time, date and temperature
for the currently selected timer.
• Press the ‘OK’ button once all the
settings have been adjusted to exit the
timer programming function. The unit will
automatically save the selected settings
to memory.
• Press the Power button on the remote
control or the unit’s control panel to reset
all programmed timers and temperature
settings.
Adjusting the Flame Effect:
• The re’s LED ame eect can be dimmed
or its colour changed between an array
of four primary colours and six mixed
colours, as required.
• Press the Dimmer button on the remote
control or the unit’s control panel to adjust
the brightness of the ame eect.
• Press the ‘Colour’ button on the unit’s
remote control while the LED ame
eect is activated to change its colour.
Repeatedly press this button to cycle
between the available colours.