Warmlite WL45038 - Appliance Adjustments and Maintenance; Adjusting LED Strip Lights; Overheat Protection

12
CUSTOMER SUPPORT TEAM: +44 (0) 333 220 6056
Adjusting the LED Strip Lights:
This unit is equipped with colour-changing LED
strip lights to either side of the main panel.
• Press the ‘Backlight’ button on the unit’s
remote control to turn the LED strip lights
on.
• Repeatedly press the ‘Backlight’ button
once the lights have been turned on to
cycle through the 6 available colours.
Press this button a seventh time to turn
the LED strip lights o.
Overheat Protection:
• The replace is equipped with an overheat
protection function, which automatically
activates whenever the unit’s inner
temperature becomes too high.
• For safety reasons, when the overheat
protection function activates, the unit will
NOT automatically turn itself o; it will
need to be reset manually.
• To manually reset the unit, unplug the unit
from the mains and wait for approximately
15 minutes. Once this time elapses,
reconnect the unit to the mains supply
and turn it on.
• If after this time the replace still fails to
operate correctly, contact our Customer
Services team or a qualied repair
technician.
TROUBLE SHOOTING
Problem Cause Solution
The unit
doesn’t
operate
No power
supply
Heat
setting not
selected or
too low
Overheat
protection
feature
activated
Connect the unit
to a functioning
power outlet.
Make sure
the relevant
heat selection
button has been
pressed.
Unplug the unit
from the mains,
wait for about
15 minutes and
plug it back in.
If it still does not
operate correctly
after this time,
consult a
qualied repair
technician or
contact our
Customer
Support team.
Low
heating
power
No LED
ame
eect/
Flame
eect too
dim
High heat
setting not
selected
Faulty or
blown LED
lamp.
Select the High
heat setting by
pressing the
2000W button
on the remote
control or the
unit’s control
panel.
Contact our
Customer
Support team
or a qualied
service engineer
for replacement.