WARN INDUSTRIES PAGE 6 80565A1
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Figure8
III. INSTALLATION cont.
8. All bumper and plow mounting bolts must now
be tightened securely. Secure all M8 bolts to 20
N-m (15 -lb.)
9. Reinstall the front skid pan with the original fac-
tory fasteners. The small shoulder bolts may be
reinstalled with a 10mm socket and extension by
passing it through the large hole on the side of
the mount.
10. Finally install the plow mounting tab to your Plow
Tube Assembly.
11. Install these loosely on the plow with the fasten-
ers provided with the plow. Tighten the fasten-
ers after the plow is assembled and installed in
the mount per the plow assembly instructions.
To Next Page
Loading...