WARRIOR W0703F - Page 14

·>[ i]Z djih^YZ ZcY d[ i]Z ZmiZch^dc l^c\
i^aihje!jhZVhig^ed[bVh`^c\iVeZVadc\
i]ZideZY\Zd[i]ZbV^ciVWaZidh]^bi]Z
ZmiZch^dcl^c\YdlchZZ #

 Note: After reinstalling wings, remove all
excess masking tape with a razor blade.
Figure 8
BVh`^c\iVeZadXVi^dc[dgh]^bb^c\
i]ZZmiZch^dciVWaZje#
Figure 7.
BVh`^c\iVeZadXVi^dc[dgh]^bb^c\
i]ZZmiZch^dcl^c\Ydlc#
Figure 8.
;gdcigV^a^chiVaaZYdchVl#
5.
Figure 9.
Figure 9.
Install the front rail with four M8×35 flat cap sc-
rews, 8mm flat washers, 8mm lock washers and
M8 hex nuts, as shown in
GZVggV^a^chiVaaZYdchVl#
6.
Figure 10.
Figure 10.
Install the rear rail with four M8×35 cap screws,
8mm flat washers, 8mm lock washers and M8
hex nuts, as shown in
 >chiVaa i]Z [ZcXZ ijWZ dc i]Z [gdci gV^a l^i]
;ZcXZijWZ^chiVaaZYdc[gdcigV^a#
Figure 11.
Figure 11.
7.
five M6×12 cap screws, as shown in
&'
#
8.  6iiVX] i]Z hl^iX] id i]Z [gdci gV^a l^i] ild
Figure 12.
M6×10 cap screws, 6mm flat washers, 6mm
lock washers as shown in

Figure 12.
Switch attached to rail